About salps
2 posters
Page 1 of 1
About salps
Hi Marc,
I want scan a sample with only salps ( >1cm) It's possible to decrease the resolution under 1200 dpi?
A part of salps isn't recognized by zooprocess because it's too transparent,
I need to create a new configuration file and change the value of the treshold ?
Thanks
I want scan a sample with only salps ( >1cm) It's possible to decrease the resolution under 1200 dpi?
A part of salps isn't recognized by zooprocess because it's too transparent,
I need to create a new configuration file and change the value of the treshold ?
Thanks
Boris- Posts : 5
Join date : 2009-03-25
Imaging salps with Zooscan
Dear Boris,
The response is to be adapted considering the purpose of your scanning. Will the results be merged with those coming from other scans done using a defined resolution or be analysed independantly ?
In the later case, you can play with the parametres... but you will never get detail of fully transparent parts => transparent = Optical density = 0 !
Try to change the threshold : open a VIS image in imageJ and use the Image/adjust/threshold to define the best value to be set in the Configuration file. Do it on few image before choosing !
Regards
Marc P.
The response is to be adapted considering the purpose of your scanning. Will the results be merged with those coming from other scans done using a defined resolution or be analysed independantly ?
In the later case, you can play with the parametres... but you will never get detail of fully transparent parts => transparent = Optical density = 0 !
Try to change the threshold : open a VIS image in imageJ and use the Image/adjust/threshold to define the best value to be set in the Configuration file. Do it on few image before choosing !
Regards
Marc P.
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|